8mmx90mm Endoscopic Cleaning Brush

Product Feature

KLD Manufacturer's 8mmx90mm Endoscopic Cleaning Brush:

The brush head fits perfectly into small-diameter instruments with an inner diameter of 8mm, including endoscope channels, dental handpiece lumens, and laboratory narrow-bore pipettes. With strictly controlled dimensional tolerances, it inserts smoothly without jamming, enables gap-free cleaning, and eliminates the common pain point of poor fitting during cleaning.

The bristles are fixed by precision spiral winding technology, featuring uniform density and moderate elasticity. They deliver strong decontamination power to easily remove residues inside the lumens, while being soft enough not to scratch the inner walls of endoscopes or the surfaces of precision instruments. This balances effective cleaning and instrument protection, thus extending the service life of the equipment.

The 8mmx90mm Endoscopic Cleaning Brush shaft has been treated for enhanced toughness, making it resistant to bending and breaking. It can flexibly pass through complex structures such as bends and connectors in endoscope channels without getting stuck. The shaft surface is smooth and burr-free to prevent damage to the inner lumen walls during wiping, and maintains stable form even after repeated use.

The handle is designed with a non-slip textured surface for a comfortable grip. Its length conforms to ergonomic hand mechanics, reducing hand fatigue during prolonged cleaning and allowing precise control of cleaning angles to improve efficiency and operating experience. A round hanging hole is built into the end for direct air-drying after use, preventing bacterial and mold growth caused by moisture, ensuring convenient and safe storage.

Instructions for Use

Pre-treatment: Rinse the endoscopes, instruments or devices to be cleaned with clean water to remove surface dust and large residues.

Cleaning operation: Hold the non-slip handle, insert the brush head slowly into the target lumen or channel, and move back and forth smoothly along the lumen. With the help of medical cleaning agents, focus on cleaning bends, connectors and other areas where dirt easily accumulates.

Thorough rinsing: After cleaning, rinse the brush and the device thoroughly with clean water to remove residual dirt and cleaning agent from the bristles and the device.

Drying and storage: Hang the 8mmx90mm Endoscopic Cleaning Brush in a dry and ventilated place through the hanging hole on the handle for air drying, then disinfect it as required for later use.

Note: Avoid excessive force during cleaning to prevent bristle deformation or shaft bending, which may affect subsequent performance.